1500W-12V
12V 1500W PURE SINE WAVE INVERTER
GENERAL INFORMATION
These pure sine wave inverters are specially designed to fulfil the needs of special applications where it is necessary to adapt several parameters of inverters.
State-of Art auto load sense
Standard inbuilt low battery cut-off
Great overload performance
Very efficient stand by circuit
Do not effect other equipment like TV, radio…etc
No problem with microwave ovens
Extremely efficient
Standard specially designed AC- and DC – line filters
Built-in standard RS232 interface
Can be used anywhere including National Parks
SPECIFICATION
Output Power Continuous: 1500W
Continuous Output Power: 2000 W
AC Output Voltage: 100-120V +/-2%
300-240V +/-2% adjustable
Output Voltage Regulation: -1.5% – +1.5%
Output Frequency: 50Hz +0.5% & 60Hz +0.5%
Output Wave Form: Pure Sine Wave <2%THD
Efficiency (Full Load): 88%
No Load Power Consumption: <4W (In power saving status)
Input Voltage Range: 10-16VDC / 20-32 VDC
Power Saving Recovery Time: 1 Second
LED Status Indication: Power ON/OFF, RUN/STAND BY,
High/Low battery shutdown, over temperature shutdown and over load shutdown
Protection Feature: Over/under input voltage, over temp., and reverse input polarity (fuse). Over load, short circuit, shutdown, restarts.
Remote Controller: Power Output ON/OFF, Run, Trip LED All in one
Operation Temperature Range: 0 Degrees Celsius – 50 Degrees Celsius
Storage Temperature Range: -30 Degrees Celsius – 70 Degrees Celsius
Dimension (LxWxH): 510mm x 285mm x 120mm
INSTRUCTION MANUAL
OPERATING THE INVERTER
Operation of the switch-mode rectifiers is done by the ON/OFF switch. In case you switch the inverter “ON” the green control LED signals operation.
In case battery voltage fall below 10.5V for 12 Version or 21.0V for 24V version during operating mode, an acoustic warning signal is given and the color of the control LED changes from green to orange.
In case the inverter is heated up too seriously, it switches off automatically and the color of the control LED changes from green to orange.
Switch the inverter off manually. After the inverter has cooled down, you it is recommendable to start engine of the vehicle so to prevent the vehicles battery getting discharged.
The Pocket Power may used either while the engine is running to turned off. However, do not start the engine with the Pocket Power in use. The voltage to the lighter plug (for inverter with lighter plug) may shut off during cranking.
The inverters of 150W and 300W are designed to automatically protect and limit output power on setting rating when overloading or short circuit, and the inverters perform auto-recovery as overloading or short circuit condition released